Downflow Unit Heaters - 30 KW Downflow Unit Heater - TPI F3F2630CA1 - 102390 BTU
30 KW Downflow Unit Heater, TPI F3F2630CA1, is equipped with 102390 BTU, 16 ga. steel cabinet with epoxy powder coated finish, control compartment with a hinged and latched access door, manual reset limit controls to de-energize the heater should an over-temperature situation occur, fan purge which allows fan to operate after elements are de-energized to purge residual heat and totally enclosed, 2 speed, 1 phase permanently lubricated, thermally protected motors with sleeve.
| TPI 30 KW Downflow Unit Heater F3F2630CA1 Specifications |
|---|
| UPC | 686334717557 |
|---|
| KW | 30 |
|---|
| BTU | 102390 |
|---|
| VOLTS | 208 |
|---|
| PHASE | 3 |
|---|
| AMPS | 83.4 |
|---|
| Control Voltage | 24 |
|---|
| Temperature Rise | 29 F |
|---|
| CFM | 3300 |
|---|
| Weight | 175 Lbs. |
|---|
TPI 30 KW Downflow Unit Heater F3F2630CA1 Features:
CONSTRUCTION:
- 16 ga. steel cabinet with epoxy powder coated finish and control compartment with a hinged and latched access door
- OSHA guards standard
HEATING ELEMENT:
- Corrosion resistant element with steel sheath and steel spiral fins
OVERHEAT PROTECTION:
- Equipped with manual reset limit controls to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR:
- Totally enclosed, 2 speed, 1 phase permanently lubricated, thermally protected motors with sleeve.
- Axial flow fan blade - 1570 RPM max.
- Equipped with fan purge which allows fan to operate after elements are de-energized to purge residual heat
TEMPERATURE CONTROLS:
- In-Built 24 volt transformer for low voltage remote thermostat application
- May operate as 2 stage heaters if 2 stage remote thermostat is used
DISCONNECT SWITCH:
- Equipped with in-built disconnect
INSTALLATION:
- Unit can be mounted using optional mounting bracket or field constructed angle iron bracket
- Not recommended for mounting with threaded rod or chain