Bring warmth this winter with 25 KW 480V 3PH Downflow Unit Heater by TPI. Model P3P2625CA1 has corrosion resistant element with steel sheath and steel spiral fins for maximum pleasure. This highly preferred unit is make ready using 16 ga. steel cabinet with epoxy powder coated finish and control compartment with a hinged and latched access door.
| TPI Downflow Unit Heater - P3P2625CA1 Specifications |
|---|
| Wattage | 25 KW |
|---|
| BTU's | 85325 BTU |
|---|
| VOLTS | 480V |
|---|
| Phase | 3 Ph |
|---|
| AMPS | 30.1 |
|---|
| Control Voltage | 24 |
|---|
| Temp Rise deg F | 24 F |
|---|
| CFM | 3300 |
|---|
| Weight | 175 lbs. |
|---|
| UPC | 686334717533 |
|---|
| Listed | ETL Listed |
|---|
Downflow Unit Heater - P3P2625CA1 Features:
CONSTRUCTION:
- 16 ga. steel cabinet with epoxy powder coated finish and control compartment with a hinged and latched access door
- OSHA guards standard
HEATING ELEMENT:
- Corrosion resisitant element with steel sheath and steel spiral fins
OVERHEAT PROTECTION:
- Equipped with manual reset limit controls to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR:
- Totally enclosed, 2 speed, 1 phase permanently lubricated, thermally protected motors with sleeve bearings
- Axial flow fan blade - 1570 RPM max.
- Equipped with Fan Purge which allows Fan to operate after elements are de-energized to purge residual heat
TEMPERATURE CONTROLS:
- In-Built 24 volt transformer for low voltage remote thermostat application
DISCONNECT SWITCH:
- Equipped with In-Built Disconnect
INSTALLATION:
- Unit can be mounted using optional mounting bracket or field constructed angle iron bracket
- Not recommended for mounting with threaded rod or chain