30 KW 480V 3PH Downflow Unit Heater is the right heater for the right job. This TPI model P3P2630CA1 is equipped with manual reset limit controls to de-energize the heater should an over-temperature situation occur. It completes with corrosion resistant element with steel sheath and steel spiral fins ensures warmth this winter.
| TPI Downflow Unit Heater - P3P2630CA1 Specifications |
|---|
| Wattage | 30 KW |
|---|
| BTU's | 102390 BTU |
|---|
| VOLTS | 480V |
|---|
| Phase | 3 Ph |
|---|
| AMPS | 36.1 |
|---|
| Control Voltage | 24 |
|---|
| Temp Rise deg F | 29 F |
|---|
| CFM | 3300 |
|---|
| Weight | 175 lbs. |
|---|
| UPC | 686334717571 |
|---|
| Listed | ETL Listed |
|---|
Downflow Unit Heater - P3P2630CA1 Features:
CONSTRUCTION:
- 16 ga. steel cabinet with epoxy powder coated finish and control compartment with a hinged and latched access door
- OSHA guards standard
HEATING ELEMENT:
- Corrosion resisitant element with steel sheath and steel spiral fins
OVERHEAT PROTECTION:
- Equipped with manual reset limit controls to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR:
- Totally enclosed, 2 speed, 1 phase permanently lubricated, thermally protected motors with sleeve bearings
- Axial flow fan blade - 1570 RPM max.
- Equipped with Fan Purge which allows Fan to operate after elements are de-energized to purge residual heat
TEMPERATURE CONTROLS:
- In-Built 24 volt transformer for low voltage remote thermostat application
DISCONNECT SWITCH:
- Equipped with In-Built Disconnect
INSTALLATION:
- Unit can be mounted using optional mounting bracket or field constructed angle iron bracket
- Not recommended for mounting with threaded rod or chain