Presenting 3.3KW Single Pole Fan Forced Suspended Unit Heater manufactured by TPI. Model no F1F5103N is manufactured using 18 gauge steel cabinet and control compartment housing a master terminal board with a hinged and latched access door, simplifying wiring, installation & maintenance. Spiral fin steel element with continuously brazed steel fins formed to allow side draw through air flow.
| TPI 3.3KW Single Pole Fan Forced Suspended Unit Heater F1F5103N Specifications |
|---|
| Power | 3.3 KW |
|---|
| BTU's | 11.2 |
|---|
| Volts | 208 |
|---|
| Phase | 1 |
|---|
| Amps | 15.9 |
|---|
| Control Volts | 208 |
|---|
| Temp Rise | 26 F |
|---|
| CFM | 400 |
|---|
| Air Throw | 12' |
|---|
| Recommended Mounting Ht.(Horizontal) | 9' |
|---|
| Recommended Mounting Ht.(Vertical) | 9' |
|---|
| Weight | 25 Lbs. |
|---|
| UPC | 686334645089 |
|---|
TPI 3.3KW Single Pole Fan Forced Suspended Unit Heater F1F5103N Features:
CONSTRUCTION:- Heavy 18 ga. welded steel cabinet with powder coated finish and control compartment housing a master terminal board with a hinged and latched access door, simplifying wiring, installation & maintenance
HEATING ELEMENT:- Copper clad steel sheath element with continuously brazed steel fins formed to allow side draw through air flow.
OVERHEAT PROTECTION:- Comes equipped with automatic reset type limit controls to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR: - Totally enclosed, 1-speed, 1-phase, permanently lubricated, thermally protected motor with unit bearing. Motor is mounted with rubber insulators to minimize vibration & noise. Fan over-ride purges unit of residual heat at shutdown
LOUVER ASSEMBLY:- Louver is individually adjustable for directional control of air flow up to 15 deg from straight horizontal. Optional diffusers available for down flow (vertical discharge) applications
TEMPERATURE CONTROLS: - Optional low voltage and line voltage thermostats available with an adjustable temperature range of 40 deg-90 degF
INSTALLATION:- It can be mounted for horizontal or vertical discharge
- For applications up to 6000 feet.
- ABS type approved
FIELD INSTALLED OPTIONS:- In-unit or wall mounted temperature control thermostats - low or line voltage
- Summer fan switch to operate the fan only.
- Power disconnect switch
- Heat stratification thermostat