Fan Forced Wall Heaters - 60 KW 5100 Series Suspended Fan Forced Unit Heater - TPI F3F5160CA1 - 204.7 BTU
We bring you 5100 Series Suspended Fan Forced Unit Heater with 60 KW and 204.7 BTU. TPI F3F5160CA1 is equipped with manual reset type limit to de-energize the heater should an over-temperature situation occur, 1 speed, ball bearing and thermally protected motors, fan over-ride purges unit of residual heat at shutdown and factory wired for low voltage controls. This amazing unit is designed for up to three stage heating operation.
| TPI 60 KW Suspended Fan Forced Unit Heater F3F5160CA1 Specifications |
|---|
| UPC | 686334721349 |
|---|
| KW | 60 |
|---|
| BTU / H | 204.7 |
|---|
| VOLTS | 208 |
|---|
| PHASE | 3 |
|---|
| AMPS | 166.7 |
|---|
| Control Voltage | 24 |
|---|
| Temperature Rise | 60 F |
|---|
| Air Throw | 50' |
|---|
| CFM | 3400 |
|---|
| Recommended Mounting Height (Horizontal) | 18' |
|---|
| Recommended Mounting Height (Vertical) | 31' |
|---|
| Weight | 141 Lbs. |
|---|
TPI 60 KW Suspended Fan Forced Unit Heater F3F5160CA1 Features:
CONSTRUCTION:
- 18 ga. steel cabinet with powder coated finish and control compartment housing a master terminal board with a hinged and latched access door, simplifying wiring, installation and maintenance.
HEATING ELEMENT:
- Spiral fin steel element with continuously brazed steel fins formed to allow side draw through air flow
OVERHEAT PROTECTION:
- Equipped with manual reset type limit to de-energize the heater should an over-temperature situation occur.
FAN and MOTOR:
- Has 1 speed, ball bearing, thermally protected motors.
- Fan over-ride purges unit of residual heat at shutdown
LOUVER ASSEMBLY:
- Louvers are individually adjustable for directional control of air flow up to 15 degree from straight horizontal
- Optional diffusers available for down flow (vertical discharge) applications
TEMPERATURE CONTROLS:
- Optional low voltage and line voltage thermostats available with an adjustable temperature range of 50 degree -90 degree F
- It is factory wired for low voltage controls.
- Designed for up to three stage heating operation.
INSTALLATION:
- Unit Heaters can be mounted for horizontal or vertical discharge
- Suggested for applications up to 6000 feet.
FIELD INSTALLED OPTIONS:
- In-Built or wall mounted temperature control thermostats - low or line voltage
- Summer fan switch to operate the fan only.
- Power disconnect switch
- Can be multiple stage when used with optional SC5100 and C1025 stat
- Heat stratification thermostat