We bring you horizontal fan forced unit heater by TPI. Model HF2HUH10C03 features heavy gauge welded steel cabinet with powder coated finish and control compartment with a hinged and latched access door. The circular copper clad steel sheath element with continuously brazed steel fins is formed to match the air delivery pattern of the fan blade. This remarkable heater comes equipped with automatic resetting type limit controls to de-energize the heater should an over-temperature situation occur.
| TPI Fan Forced Unit Heater HF2HUH10C03 Specifications |
|---|
| Wattage | 10000 / 7500 W |
|---|
| BTUs | 34100 / 25600 BTU |
|---|
| Voltage | 240 / 208 V |
|---|
| Phase | 1 / 3 |
|---|
| Amps (240 V) | 41.7/24.1 A |
|---|
| Amps (208 V) | 36.1/20.8 A |
|---|
| Control Voltage | 240 / 208 V |
|---|
| Temperature Rise | 55 to 42 F |
|---|
| Air Throw | 36' |
|---|
| CFM | 575 |
|---|
| Recommended Mounting Height | 9' |
|---|
| Dimension | 20" H x 11" D x 13" W |
|---|
| Weight | 45 Lbs. |
|---|
| UPC | 686334644976 |
|---|
| Listed | ETL Listed |
|---|
TPI Fan Forced Unit Heater HF2HUH10C03 Features:
- Construction:
Heavy gauge welded steel cabinet with powder coated finish and control compartment with a hinged and latched access door, simplifying wiring installation & maintenance. - Heating Element:
Circular copper clad steel sheath element with continuously brazed steel fins formed to match the air delivery pattern of the fan blade. - Overheat Protection:
Comes equipped with automatic resetting type limit controls to de-energize the heater should an over-temperature situation occur. - Fan & Motor:
Totally enclosed, single or three phase, permanently lubricated, thermally protected motor with unit bearing. Fan assembly enclosed by a heavy gauge, close spaced, chrome plated wire guard. - Louver Assembly:
Louver is individually adjustable for directional control of air flow and the entire assembly can be repositioned in the field from down flow to up flow or left / right directional air flow. - Installation:
This ETL listed heater can be mounted with the motor shaft from horizontal to downward at 45 degrees off horizontal. Pre-drilled holes and installed threaded nuts provided to allow hanging by 1/4" threaded rod. Optional wall / ceiling mounting brackets are available for this unit. - Factory Installed Options:
24 volt transformer to convert from line voltage to low voltage remote thermostat operation.
Summer fan switch to operate the fan only.
Fan delay switch to purge all residual heat from the unit after the heating element has cycled off. Includes contactor and transformer.
Powder coated epoxy finish for corrosive atmospheres.
Disconnect switch. - Note: Louver assembly is square and mounted with screws. Louver can be removed and repositioned for four (4) directional air flow - left - right - up - down with the heater in the horizontal position.