Electric Forced Air Heaters - 5000 W, 17.1 BTU 17-3/4" 5100 Series Unit Heater - TPI G1G5105N
Highly efficient and cost effective Electric Forced Air Heaters made by TPI. Model G1G5105N is 5000 W, 17-3/4" high 5100 Series Unit Heater. It gives an amazing 17.1 BTU output. This model is constructed of 18 ga. steel cabinet with powder coated finish and control compartment housing a master terminal board with a hinged and latched access door which simplify wiring, installation and maintenance. The model comes with fan and motor which are totally enclosed, 1-speed, 1-phase, permanently lubricated and thermally protected motors.
| 5100 Series Unit Heater - 17.1 BTU - TPI G1G5105N Specifications |
|---|
| BTU | 17.1 |
|---|
| KW | 5 KW |
|---|
| TEMP RISE | 40 F |
|---|
| CFM | 400 |
|---|
| Amps. | 18.1 |
|---|
| Phase | 1 PH |
|---|
| Air throw | 12' |
|---|
| Voltage | 277V |
|---|
| Control Volts | 277 |
|---|
| Recommended Mounting Height Hortz | 9' |
|---|
| Recommended Mounting Height Vert | 9' |
|---|
| Product Dimension | 17-3/4"H x 14-15/32"W x 6-1/2"D |
|---|
| Weight | 27 Lbs. |
|---|
| UPC | 686334645843 |
|---|
5100 Series Unit Heater - 17.1 BTU - TPI G1G5105N Features:
CONSTRUCTION:
- 18 ga. steel cabinet with powder coated finish and control compartment housing a master terminal board with a hinged and latched access door, simplifying wiring, installation & maintenance
HEATING ELEMENT:
Spiral fin steel element with continuously brazed steel fins formed to allow side draw through air flow
OVERHEAT PROTECTION:
- This 5 KW unit equipped with automatic reset type limit.
FAN and MOTOR:
- Totally enclosed, 1-speed, 1-phase, permanently lubricated, thermally protected motors with unit this 5 KW model.
- Fan over-ride purges unit of residual heat at shutdown
LOUVER ASSEMBLY:
- Louvers are individually adjustable for directional control of air flow up to 15 Deg. from straight horizontal.
- Optional diffusers available for down flow (vertical discharge) applications
TEMPERATURE CONTROLS:
- Optional low voltage and line voltage thermostats available with an adjustable temperature range of 50 deg -90 deg F
- Units with model numbers ending in CA1 are factory wired for low voltage controls
INSTALLATION:
- This unit heaters can be mounted for horizontal or vertical discharge
- 5100 series suggested for applications up to 6000 feet; for applications up to or above 6000 feet see UH series.
FIELD INSTALLED OPTIONS:
- In-Built or wall mounted temperature control thermostats - low or line voltage
- Summer fan switch to operate the fan only.
- Power disconnect switch
- Heat stratification thermostat
- UL listed